Difference between revisions of "NXP MIMXRT106A-ALEXA2"
(→Example Project) |
|||
Line 18: | Line 18: | ||
== Example Project== |
== Example Project== |
||
− | |||
− | |||
− | |||
− | SETUP |
||
− | |||
− | J-Link software: V6.82a |
||
− | Embedded Studio: V4.50 |
||
− | Hardware: NXP MIMXRT595-EVK (Rev C1) |
||
− | Link: File:NXP MIMXRT595-EVK-RevC1 QSPI ES.zip |
||
− | |||
− | |||
The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone. |
The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone. |
||
'''SETUP''' |
'''SETUP''' |
Revision as of 11:02, 15 February 2022
This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board.
TBD
Minimum requirements
- J-Link software V6.83c or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J6)
- Power the board via USB C cable (CON1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
TBD
Example Project
The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone. SETUP
- J-Link software: V6.83c
- Embedded Studio: V4.52b
- Hardware: NXP MIMXRT106A-ALEXA2 IoT (QSPI enabled)
- Link: File:NXP MIMXRT106A-ALEXA2 QSPI TestProject ES V452b.zip