Difference between revisions of "NXP PNEV76FAMA"
(→Preparing for J-Link) |
|||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the NXP PNEV76FAMA evaluation board. It can be used to test & verify PN76 device support with J-Link. |
+ | This article describes specifics for the NXP PNEV76FAMA evaluation board. It can be used to test & verify [[NXP PN76 |PN76]] device support with J-Link. |
[[File:NXP_PNEV76FAMA.jpeg|450px]] |
[[File:NXP_PNEV76FAMA.jpeg|450px]] |
||
Line 22: | Line 22: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP PNEV76FAMA. It is a simple Hello World sample linked into the internal flash. |
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.65b |
*J-Link software: V7.65b |
Revision as of 14:52, 28 April 2022
This article describes specifics for the NXP PNEV76FAMA evaluation board. It can be used to test & verify PN76 device support with J-Link.
Minimum requirements
- J-Link software V7.65b or later
Preparing for J-Link
- For board REV D remove jumper J20 3-4 and connect pin 4 of J20 to any ground e.g. TP4. Keep J25 open.
- Connect the J-Link to the debug connector (J21)
- Power the board via USB (J5)
Afterwards, the board should look similar to this:
Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP PNEV76FAMA. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.65b
- Embedded Studio: V6.22
- Hardware: NXP PNEV76FAMA
- Link: File:NXP PNEV76FAMA ES V622.zip