NXP PNEV76FAMA

From SEGGER Wiki
Revision as of 11:58, 28 April 2022 by Matthias (talk | contribs) (Created page with "__TOC__ This article describes specifics for the NXP PNEV76FAMA evaluation board. It can be used to test & verify PN76 device support with J-Link. File:NXP_PNEV76FAMA.jpeg...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the NXP PNEV76FAMA evaluation board. It can be used to test & verify PN76 device support with J-Link.

NXP PNEV76FAMA.jpeg

Minimum requirements

  • J-Link software V7.65b or later

Preparing for J-Link

  • For board REV D remove jumper J20 3-4 and connect pin 4 of J20 to any ground e.g. TP4. Keep J25 open.
  • Connect the J-Link to the debug connector (J21)
  • Power the board via external power supply / power jack (J9 / 5V DC)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP PNEV76FAMA Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP S32K3X4EVB. It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_PNEV76FAMA&oldid=11842"