NXP S32K3X4EVB

From SEGGER Wiki
Revision as of 12:54, 22 December 2021 by Erik (talk | contribs) (Created page with "__TOC__ This article describes specifics for the NXP S32K3X4EVB evaluation board. It can be used to test & verify S32K344 device support with J-Link. File:NXP_S32K3X4EVB|4...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the NXP S32K3X4EVB evaluation board. It can be used to test & verify S32K344 device support with J-Link.

450px

Minimum requirements

  • J-Link software V6.70 or later

Preparing for J-Link

  • Connect the J-Link to the debug connector (J365)
  • Power the board via external power supply / power jack (VBAT / 12V DC)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP S32K3x4EVB Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP S32K3X4EVB. It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_S32K3X4EVB&oldid=11237"