Difference between revisions of "NXP i.MX RT685 SuperMonkey"
(Created page with "__TOC__ This article describes specifics for the NXP i.MX RT685 SuperMonkey evaluation board. 450px == Minimum requirements == * J-Link softw...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:26, 8 May 2024
This article describes specifics for the NXP i.MX RT685 SuperMonkey evaluation board.
Minimum requirements
- J-Link software V7.65b or later
Preparing for J-Link
- Connect the J-Link to the debug connector (J3)
- Power the board via USB
Afterwards, the board should look similar to this:
Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP i.MX RT685 SuperMonkey. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.65b
- Embedded Studio: V6.22
- Hardware: NXP i.MX RT685 SuperMonkey
- Link: File:NXP SuperMonkey ES V622.zip