Difference between revisions of "Nuvoton NuMaker-M471R1"
(Created page with "__TOC__ This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board. 600px == Minimum requirements == * J-Link soft...") |
|||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the Nuvoton NuMaker- |
+ | This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board. |
[[File:Nuvoton_NuMaker-M263KI.jpg|600px]] |
[[File:Nuvoton_NuMaker-M263KI.jpg|600px]] |
||
Line 21: | Line 21: | ||
*J-Link software: V7.84b |
*J-Link software: V7.84b |
||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
− | *Hardware: Nuvoton NuMaker- |
+ | *Hardware: Nuvoton NuMaker-M471R1 |
− | *Link: [[File:Nuvoton_NuMaker- |
+ | *Link: [[File:Nuvoton_NuMaker-M471R1_M471R1E6AE_TestProject_ES_V634.zip]] |
Revision as of 16:34, 17 January 2023
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board.
Minimum requirements
- J-Link software V7.84b or later
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
- Power the board via J2 (USB OTG) or ICEJ3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.84b
- Embedded Studio: V6.34
- Hardware: Nuvoton NuMaker-M471R1
- Link: File:Nuvoton NuMaker-M471R1 M471R1E6AE TestProject ES V634.zip