Difference between revisions of "Nuvoton NuMaker-M471R1"

From SEGGER Wiki
Jump to: navigation, search
Line 13: Line 13:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
   
−
[[File:Nuvoton_NuMaker-M263KI_M263KIAAE_Connect.png|400px]]
 +
[[File:Nuvoton_NuMaker-M471R1_M471R1E6AE_Connect.png|400px]]
   
 
== Example Project==
  
== Example Project==

Revision as of 16:34, 17 January 2023

This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board.

Nuvoton NuMaker-M263KI.jpg

Minimum requirements

  • J-Link software V7.84b or later

Preparing for J-Link

  • Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
  • Power the board via J2 (USB OTG) or ICEJ3
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Nuvoton NuMaker-M471R1 M471R1E6AE Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Nuvoton_NuMaker-M471R1&oldid=13992"