Difference between revisions of "Nuvoton NuMaker-M471R1"
| (One intermediate revision by the same user not shown) | |||
| Line 3: | Line 3: | ||
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board. |
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board. |
||
| − | [[File:Nuvoton |
+ | [[File:Nuvoton NuMaker-M471RI.jpg|600px]] |
== Minimum requirements == |
== Minimum requirements == |
||
| Line 10: | Line 10: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
*Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6 |
*Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6 |
||
| − | *Power the board via J2 (USB |
+ | *Power the board via J2 (USB) or ICEJ3 |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Revision as of 07:56, 14 June 2023
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board.
Minimum requirements
- J-Link software V7.84b or later
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
- Power the board via J2 (USB) or ICEJ3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.84b
- Embedded Studio: V6.34
- Hardware: Nuvoton NuMaker-M471R1
- Link: File:Nuvoton NuMaker-M471RI M471R1E6AE TestProject ES V634.zip
