Difference between revisions of "Nuvoton NuMaker-M471R1"
Line 3: | Line 3: | ||
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board. |
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board. |
||
− | [[File:Nuvoton |
+ | [[File:Nuvoton NuMaker-M471RI.jpg|600px]] |
== Minimum requirements == |
== Minimum requirements == |
Revision as of 07:56, 14 June 2023
This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board.
Minimum requirements
- J-Link software V7.84b or later
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
- Power the board via J2 (USB) or ICEJ3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.84b
- Embedded Studio: V6.34
- Hardware: Nuvoton NuMaker-M471R1
- Link: File:Nuvoton NuMaker-M471RI M471R1E6AE TestProject ES V634.zip