Difference between revisions of "ONSemi RSL10 SiP"
(Created page with "== Example Application== The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ON Semiconductor RSL10 SiP EVB...") |
(→Example Application) |
||
Line 1: | Line 1: | ||
+ | __TOC__ |
||
+ | |||
+ | This article describes specifics for the ON Semiconductor RSL10 SiP evaluation board. |
||
+ | |||
+ | [[File:ONSemi_RSL10.jpg|450px]] |
||
+ | |||
+ | == Minimum requirements == |
||
+ | * J-Link software V6.89c or later |
||
+ | |||
+ | == Preparing for J-Link == |
||
+ | This step is very easy as the RSL10 SiP features a J-Link OB (on-board debugger) which works out-of-the-box. |
||
+ | *Connect the board via USB to the PC (USB is also used as power supply) |
||
+ | *Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
+ | |||
+ | [[File:ONSemi_RSL10_Connect.PNG|400px]] |
||
+ | |||
== Example Application== |
== Example Application== |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ON Semiconductor RSL10 SiP EVB V1.2. It is a simple Hello World sample linked into the internal flash. |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ON Semiconductor RSL10 SiP EVB V1.2. It is a simple Hello World sample linked into the internal flash. |
Revision as of 13:09, 4 December 2020
This article describes specifics for the ON Semiconductor RSL10 SiP evaluation board.
Minimum requirements
- J-Link software V6.89c or later
Preparing for J-Link
This step is very easy as the RSL10 SiP features a J-Link OB (on-board debugger) which works out-of-the-box.
- Connect the board via USB to the PC (USB is also used as power supply)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Application
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ON Semiconductor RSL10 SiP EVB V1.2. It is a simple Hello World sample linked into the internal flash.
SETUP:
- J-Link software: V6.89c
- Embedded Studio: V5.10b
- Hardware: ON Semiconductor RSL10 SiP EVB V1.2
- Link: File:ONSemi RSL10 TestProject ES V510b.zip