Difference between revisions of "RTT Ramcode Sample for Cortex-M0+ (Keil MDK)"
(→Manual) |
|||
Line 16: | Line 16: | ||
= Manual = |
= Manual = |
||
− | After |
+ | #After downloading and unzipping the project, open it with Keil µVision V5.24.2.0 or later. |
− | Build(F7) the project and start debugging by clicking on the Debug button (Ctrl + F5) |
+ | #Build(F7) the project and start debugging by clicking on the Debug button (Ctrl + F5) |
− | + | #Start RTT Viewer and connect with the following settings: |
|
− | [[File:CortexM0+_RTT_Settings.PNG|left|thumb|RTT Viewer Settings]] |
+ | [[File:CortexM0+_RTT_Settings.PNG|left|thumb|RTT Viewer Settings]]<br><br><br><br><br><br><br><br><br><br><br> |
− | Running the ramcode (F5) in Keil results in the following output in RTT viewer: |
+ | Running the ramcode (F5) in Keil results in the following output in RTT viewer:<br><br> |
− | [[File:CortexM0+ RTT Output.PNG|left|thumb|RTT Viewer output]] |
+ | [[File:CortexM0+ RTT Output.PNG|left|thumb|RTT Viewer output]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br> |
= Tested Hardware = |
= Tested Hardware = |
Revision as of 15:42, 8 May 2019
This article describes how to get started with RTT within RAM on a Cortex-M0+ device. This article assumes that there is already a basic knowledge about RTT in general (what is RTT, etc.). If this is not the case, we recommend to read RTT chapter in the J-Link User Manual (UM08001).
Minimum requirements
In order to use ETB trace on the ATMEL ATSAMD21 devices, the following minimum requirements have to be met:
- J-Link software version V6.44g or later
- µVision V5.24.2.0 or later (if the sample project from below shall be used)
- J-Link Plus HW version V10.1 or later
Sample project
RTT Ramcode
The following sample project is designed to be used with J-Link and Keil MDK to demonstrate RTT. The project has been tested with the minimum requirements mentioned above and a SAMD21 XPlained Pro evalboard. The sample project comes with a pre-configured project for Keil MDK that runs out-of-the box.
Manual
- After downloading and unzipping the project, open it with Keil µVision V5.24.2.0 or later.
- Build(F7) the project and start debugging by clicking on the Debug button (Ctrl + F5)
- Start RTT Viewer and connect with the following settings:
Running the ramcode (F5) in Keil results in the following output in RTT viewer: