Difference between revisions of "Renesas ASSP EASY"
(→Reset) |
(→Internal Flash) |
||
| Line 12: | Line 12: | ||
| Config Flash || 0x01010008 || up tp 44 B || style="text-align:center;"| {{YES}} |
| Config Flash || 0x01010008 || up tp 44 B || style="text-align:center;"| {{YES}} |
||
|- |
|- |
||
| − | | Data Flash || 0x40100000 || 4 KB || style="text-align:center;"| {{YES}} |
+ | | Data Flash || 0x40100000 || up to 4 KB || style="text-align:center;"| {{YES}} |
|} |
|} |
||
Revision as of 17:28, 18 March 2024
The Renesas ASSP easy are RISC-V based microcontrollers.
Contents
Flash Banks
Internal Flash
| Flash Bank | Base address | Size | J-Link Support |
|---|---|---|---|
| Code Flash | 0x00000000 | up to 128 KB | 
|
| Config Flash | 0x01010008 | up tp 44 B |
|
| Data Flash | 0x40100000 | up to 4 KB |
|
ECC RAM
- Device has ECC RAM which has to be initialized before use.
Watchdog Handling
- The device does not have a watchdog.
- The device has a watchdog [WATCHDOGNAME].
- The watchdog is fed during flash programming.
- If the watchdog is enabled, it is turned off during flash programming and turned back on afterwards.
Multi-Core Support [OPTIONAL]
Before proceeding with this article, please check out the generic article regarding Multi-Core debugging here.
The [DeviceFamily]family comes with a variety of multi-core options.
Some devices from this family feature a secondary core which is disabled after reset / by default.
Some of the are available with enabled lockstep mode, only.
In below, the debug related multi-core behavior of the J-Link is described for each core:
Main core
Init/Setup
- Initializes the ECC RAM, see XXX
- Enables debugging
Reset
- Device specific reset is performed, see XXX
Attach
- Attach is not supported because the J-Link initializes certain RAM regions by default
Secondary core(s)
Init/Setup
- If the main core session has not been started / debugging is not enabled yet, the secondary core executes the enable debug sequence.
- If the secondary core is not enabled yet, it will be enabled / release from reset
Reset
No reset is performed.
Attach
- Attach is supported / desired
Device Specific Handling
Connect
Reset
- The device uses normal RISC-V reset, no special handling necessary, like described here.
Limitations
Dual Core Support
Some XXX devices feature a second core. Right now, the J-Link software does support the main core, only. Support for the second core is planned for future versions.
Attach
Attach is not supported by default because the J-Link initializes certain RAM regions by default.
