Difference between revisions of "Renesas ASSP EASY"
(→ECC RAM) |
(→Multi-Core Support [OPTIONAL]) |
||
Line 23: | Line 23: | ||
*The watchdog is fed during flash programming. |
*The watchdog is fed during flash programming. |
||
*If the watchdog is enabled, it is turned off during flash programming and turned back on afterwards. |
*If the watchdog is enabled, it is turned off during flash programming and turned back on afterwards. |
||
− | |||
− | ==Multi-Core Support [OPTIONAL]== |
||
− | Before proceeding with this article, please check out the generic article regarding Multi-Core debugging [[Multi-Core_Debugging | here]].<br> |
||
− | The [DeviceFamily]family comes with a variety of multi-core options.<br> |
||
− | Some devices from this family feature a secondary core which is disabled after reset / by default.<br> |
||
− | Some of the are available with enabled ''lockstep'' mode, only. <br> |
||
− | In below, the debug related multi-core behavior of the J-Link is described for each core: |
||
− | ===Main core=== |
||
− | ====Init/Setup==== |
||
− | *Initializes the ECC RAM, see [[XXX | XXX]] |
||
− | *Enables debugging |
||
− | ====Reset==== |
||
− | *Device specific reset is performed, see [[XXX | XXX]] |
||
− | ====Attach==== |
||
− | *Attach is not supported because the J-Link initializes certain RAM regions by default |
||
− | ===Secondary core(s)=== |
||
− | ====Init/Setup==== |
||
− | *If the main core session has not been started / debugging is not enabled yet, the secondary core executes the enable debug sequence. |
||
− | *If the secondary core is not enabled yet, it will be enabled / release from reset |
||
− | ====Reset==== |
||
− | No reset is performed. |
||
− | ====Attach==== |
||
− | *Attach is supported / desired |
||
==Device Specific Handling== |
==Device Specific Handling== |
Revision as of 17:30, 18 March 2024
The Renesas ASSP easy are RISC-V based microcontrollers.
Contents
Flash Banks
Internal Flash
Flash Bank | Base address | Size | J-Link Support |
---|---|---|---|
Code Flash | 0x00000000 | up to 128 KB | |
Config Flash | 0x01010008 | up tp 44 B | |
Data Flash | 0x40100000 | up to 4 KB |
ECC RAM
- Device has ECC RAM which has to be initialized before use.
Watchdog Handling
- The device does not have a watchdog.
- The device has a watchdog [WATCHDOGNAME].
- The watchdog is fed during flash programming.
- If the watchdog is enabled, it is turned off during flash programming and turned back on afterwards.
Device Specific Handling
Connect
Reset
- The device uses normal RISC-V reset, no special handling necessary, like described here.
Limitations
Dual Core Support
Some XXX devices feature a second core. Right now, the J-Link software does support the main core, only. Support for the second core is planned for future versions.
Attach
Attach is not supported by default because the J-Link initializes certain RAM regions by default.