Difference between revisions of "Renesas Evaluation Kit RE01 1500KB"
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the Renesas Evaluation Kit RE01 1500KB. |
This article describes specifics for the Renesas Evaluation Kit RE01 1500KB. |
||
Latest revision as of 15:15, 8 May 2024
Contents
This article describes specifics for the Renesas Evaluation Kit RE01 1500KB.
QSPI Flash Programming Support
Before continuing with this article, please read the generic article about QSPI flash programming support on Renesas RE01 devices (Renesas RE01 QSPI). The pinout used on the Evaluation Kit RE01 1500KB, is given below.
Quad-SPI Interface Pins
The Renesas Evaluation Kit RE01 1500KB uses the following port pins to interface the (Q)SPI flash.
| Alternate function | Pin |
|---|---|
| QSPCLK_A | P602 |
| QSSL_A | P601 |
| QIO0_A | P500 |
| QIO1_A | P015 |
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas Evaluation Kit RE01 1500KB. It is a simple RTT Hello World sample linked into the internal flash and the QSPI flash. One function (_FuncInQSPI) is located in the QSPI-Flash.
Requirements
- J-Link Software V6.71c or above
- Embedded Studio: V4.52 or above
- Hardware: Renesas Evaluation Kit RE01 1500KB
- Link: File:Renesas RE01 1500KB EVK QSPI SES Example.zip
