Renesas Evaluation Kit RE01 1500KB
Contents
This article describes specifics for the Renesas Evaluation Kit RE01 1500KB.
QSPI Flash Programming Support
Before continuing with this article, please read the generic article about QSPI flash programming support on Renesas RE01 devices (Renesas RE01 QSPI). The pinout used on the Evaluation Kit RE01 1500KB, is given below.
Embedded Studio example project
The example project contains a simple RTT application which is linked into the (Q)SPI flash memory region @ address 0x60000000. It runs out-of-the-box. Please note, that SEGGER Embedded Studio for ARM must at least use the J-Link DLL version V6.71c, which supports the QSPI flash.
The project has been tested with SEGGER Embedded Studio for ARM 4.52 with an updated J-Link DLL.
Quad-SPI Interface Pins
The Renesas Evaluation Kit RE01 1500KB uses the following port pins to interface the (Q)SPI flash.
Alternate function | Pin |
---|---|
QSPCLK_A | P602 |
QSSL_A | P601 |
QIO0_A | P500 |
QIO1_A | P015 |
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas Evaluation Kit RE01 1500KB. It is a simple Hello World sample linked into the internal flash and the QSPI flash. One function (_FuncInQSPI) is located in the QSPI-Flash.
Requirements
- J-Link Software V6.72
- Embedded Studio: V4.52
- Hardware: Renesas Evaluation Kit RE01 1500KB
- Link: File:Renesas RE01 1500KB EVK QSPI SES Example.zip