Difference between revisions of "Renesas Evaluation Kit RE01 256KB"
Line 21: | Line 21: | ||
| QIO1_A || P810 |
| QIO1_A || P810 |
||
|} |
|} |
||
+ | |||
+ | ==== Example Project ==== |
||
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas Evaluation Kit RE01 256KB. It is a simple [[RTT]] Hello World sample linked into the internal flash and the QSPI flash. |
||
+ | One function (_FuncInQSPI) is located in the QSPI-Flash. |
||
+ | |||
+ | ===== Requirements ===== |
||
+ | * J-Link Software V6.82 or above |
||
+ | * Embedded Studio: V4.52 or above |
||
+ | * Hardware: Renesas Evaluation Kit RE01 256KB |
||
+ | * Link: [[File:Renesas_RE01_256KB_EVK_QSPI_SES_Example.zip]] |
Revision as of 10:44, 2 July 2020
Contents
This article describes specifics for the Renesas Evaluation Kit RE01 256KB.
QSPI Flash Programming Support
Before continuing with this article, please read the generic article about QSPI flash programming support on Renesas RE01 devices (Renesas RE01 QSPI). The pinout used on the Evaluation Kit RE01 256KB, is given below.
Quad-SPI Interface Pins
The Renesas Evaluation Kit RE01 256KB uses the following port pins to interface the (Q)SPI flash.
Alternate function | Pin |
---|---|
QSPCLK_A | P812 |
QSSL_A | P807 |
QIO0_A | P811 |
QIO1_A | P810 |
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas Evaluation Kit RE01 256KB. It is a simple RTT Hello World sample linked into the internal flash and the QSPI flash. One function (_FuncInQSPI) is located in the QSPI-Flash.
Requirements
- J-Link Software V6.82 or above
- Embedded Studio: V4.52 or above
- Hardware: Renesas Evaluation Kit RE01 256KB
- Link: File:Renesas RE01 256KB EVK QSPI SES Example.zip