Difference between revisions of "Renesas FPB-R9A02G021"
(Created page with "__TOC__ This article describes specifics for the Renesas FPB-R9A02G021 evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for J-...") |
(→Preparing for J-Link) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
This article describes specifics for the Renesas FPB-R9A02G021 evaluation board.<br> |
This article describes specifics for the Renesas FPB-R9A02G021 evaluation board.<br> |
||
+ | [[File:Renesas_FPB-R9A02G021_R9A02G021_board.jpg|450px]] |
||
− | '''[PICTURE OF BOARD]''' |
||
− | [[File:VENDOR_BOARDNAME.jpg|450px]] |
||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 9: | Line 8: | ||
*Power the board via J17. |
*Power the board via J17. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
+ | [[File:Renesas_FPB-R9A02G021_R9A02G021_connect.png|400px]] |
||
− | '''[PICTURE OF CONNECT]''' |
||
− | [[File:VENDOR_DEVICE_CONNECT.PNG|400px]] |
||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-R9A02G021.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
− | *Embedded Studio: V7.20 |
+ | *Embedded Studio RISC-V: V7.20 |
− | *Hardware: |
+ | *Hardware: Renesas FPB-R9A02G021 |
− | *Link: [[File: |
+ | *Link: [[File:Renesas_Sapporo5_R9A02G021_TestProject_ES_RV_7V20.zip]] |
Latest revision as of 12:13, 19 March 2024
This article describes specifics for the Renesas FPB-R9A02G021 evaluation board.
Preparing for J-Link
- Connect the J-Link to J15.
- Power the board via J17.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-R9A02G021.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio RISC-V: V7.20
- Hardware: Renesas FPB-R9A02G021
- Link: File:Renesas Sapporo5 R9A02G021 TestProject ES RV 7V20.zip