Renesas FPB-RA6E1
Revision as of 11:34, 19 October 2021 by Daniel (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Renesas FPB-RA6E1 evaluation board. It can be used to test & verify Renesas RA6E1 support. 450px...")
This article describes specifics for the Renesas FPB-RA6E1 evaluation board. It can be used to test & verify Renesas RA6E1 support.
Minimum requirements
- J-Link software V7.58 or later
Preparing for J-Link
- Attach the board over the debug USB-port to your PC (J9 - J-Link OB). This will power the board as well.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-RA6E1. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.58
- Embedded Studio:
- Hardware: Renesas FPB-RA6E1
- Link: File:TestAPP ProgFlash RA6E1.zip