Difference between revisions of "Renesas RZ/A3UL SMARC EVK"
(→Preparing for J-Link) |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:33, 8 May 2024
This article describes specifics for the Renesas RZ/A3UL SMARC evaluation board. The board supports different boot / power modes.
Minimum requirements
- J-Link software V7.70a or later
Preparing for J-Link
- Make sure that SW1-1 == OFF (default is ON). This is necessary to enable debugging.
- Connect the J-Link to the SWD header (CN2)
- Power the board via USB-C (5V / 3A)
- Press the POWER button for a few seconds until the Carrier PWR On led turns on
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
- N/A