Difference between revisions of "Renesas RZ/A3UL SMARC EVK"
| Line 7: | Line 7: | ||
== Minimum requirements == |
== Minimum requirements == |
||
* J-Link software V7.70a or later |
* J-Link software V7.70a or later |
||
| − | |||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
*Connect the J-Link to the SWD header (CN2) |
*Connect the J-Link to the SWD header (CN2) |
||
| Line 13: | Line 12: | ||
*Press the POWER button for a few seconds until the ''Carrier PWR On'' led turns on |
*Press the POWER button for a few seconds until the ''Carrier PWR On'' led turns on |
||
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | |||
[[File:Renesas_RZ_A3UL_SMARC_Connect.PNG|400px]] |
[[File:Renesas_RZ_A3UL_SMARC_Connect.PNG|400px]] |
||
| − | |||
== Example Project== |
== Example Project== |
||
*N/A |
*N/A |
||
Revision as of 16:36, 9 August 2022
This article describes specifics for the Renesas RZ/A3UL SMARC evaluation board. The board supports different boot / power modes.
Minimum requirements
- J-Link software V7.70a or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN2)
- Power the board via USB-C (5V / 3A)
- Press the POWER button for a few seconds until the Carrier PWR On led turns on
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
- N/A
