Difference between revisions of "Renesas RZ/A3UL SMARC EVK"
Line 2: | Line 2: | ||
This article describes specifics for the Renesas RZ/A3UL SMARC evaluation board. The board supports different boot / power modes. |
This article describes specifics for the Renesas RZ/A3UL SMARC evaluation board. The board supports different boot / power modes. |
||
+ | [[File:Renesas_RZ_A3UL_SMARC_EVK.jpg|450px]] |
||
− | |||
− | [[File:Renesas_RZ/A3UL_SMARC_EVK.jpg|450px]] |
||
− | |||
== Minimum requirements == |
== Minimum requirements == |
||
* J-Link software V7.70a or later |
* J-Link software V7.70a or later |
Revision as of 16:58, 9 August 2022
This article describes specifics for the Renesas RZ/A3UL SMARC evaluation board. The board supports different boot / power modes.
Minimum requirements
- J-Link software V7.70a or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN2)
- Power the board via USB-C (5V / 3A)
- Press the POWER button for a few seconds until the Carrier PWR On led turns on
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
- N/A