Difference between revisions of "Renesas RZ/G2L SMARC EVK"
m (Matthias moved page NXP RZG2L SWARC EVK to Renesas RZG2L SWARC EVK: Wrong page title) |
(→Example Project) |
||
Line 17: | Line 17: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas RZ/G2L. It is a simple Hello World sample linked into the internal RAM.<br> |
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.22 |
*J-Link software: V7.22 |
||
*Embedded Studio: V5.42 |
*Embedded Studio: V5.42 |
||
− | *Hardware: Renesas |
+ | *Hardware: Renesas RZ/G2L EVK (SWARC module) |
*Link: [[File:Renesas_RZG2L_RAM_TestProject_ES_V542.zip]] |
*Link: [[File:Renesas_RZG2L_RAM_TestProject_ES_V542.zip]] |
Revision as of 13:22, 4 June 2021
This article describes specifics for the Renesas RZG2L EVK. A generic startup guide + additional information can be found on Renesas website.
Minimum requirements
- J-Link software V7.22 or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN2) on the SWARC module
- Power the board via CN6 (Power Input)
- Press the POWER button (SW9) in order to supply the SWARC module with power
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas RZ/G2L. It is a simple Hello World sample linked into the internal RAM.
SETUP
- J-Link software: V7.22
- Embedded Studio: V5.42
- Hardware: Renesas RZ/G2L EVK (SWARC module)
- Link: File:Renesas RZG2L RAM TestProject ES V542.zip