Difference between revisions of "Renesas RZ/G2L SMARC EVK"
(→SETUP) |
|||
(3 intermediate revisions by 2 users not shown) | |||
Line 9: | Line 9: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to the SWD header (CN2) on the |
+ | *Connect the J-Link to the SWD header (CN2) on the SMARC module |
*Power the board via CN6 (Power Input) |
*Power the board via CN6 (Power Input) |
||
− | *Press the POWER button (SW9) in order to supply the |
+ | *Press the POWER button (SW9) in order to supply the SMARC module with power |
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Line 21: | Line 21: | ||
*J-Link software: V7.22 |
*J-Link software: V7.22 |
||
*Embedded Studio: V5.42 |
*Embedded Studio: V5.42 |
||
− | *Hardware: Renesas RZ/G2L EVK ( |
+ | *Hardware: Renesas RZ/G2L EVK (SMARC module) |
*Link: [[File:Renesas_RZG2L_RAM_TestProject_ES_V542.zip]] |
*Link: [[File:Renesas_RZG2L_RAM_TestProject_ES_V542.zip]] |
Latest revision as of 12:15, 7 June 2021
This article describes specifics for the Renesas RZ/G2L EVK. A generic startup guide + additional information can be found on Renesas website.
Minimum requirements
- J-Link software V7.22 or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN2) on the SMARC module
- Power the board via CN6 (Power Input)
- Press the POWER button (SW9) in order to supply the SMARC module with power
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas RZ/G2L. It is a simple Hello World sample linked into the internal RAM.
SETUP
- J-Link software: V7.22
- Embedded Studio: V5.42
- Hardware: Renesas RZ/G2L EVK (SMARC module)
- Link: File:Renesas RZG2L RAM TestProject ES V542.zip