Difference between revisions of "Renesas RZ/N2L-RSK"
(Created page with "__TOC__ This article describes specifics for the Renesas RZ/N2L-RSK evaluation board. 450px == Minimum requirements == * J-Link software V7.7...") |
(No difference)
|
Revision as of 15:00, 10 August 2022
This article describes specifics for the Renesas RZ/N2L-RSK evaluation board.
Minimum requirements
- J-Link software V7.70a or later
Preparing for J-Link
- Connect the J-Link to the debug header (J13 or J20)
- Power the board via USB C (CN5) or external power supply / power jack (CN6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
TBD
SETUP
TBD