Difference between revisions of "SPC560D-Discovery Evalboard"
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
The ST SPC560D-Discovery evaluation board needs to be setup manually before it can be debugged using an external J-link because by default, the on board debugger drives the debug pins. To isolate the on board debugger from the MCU, in order to make sure that it does not interact with the J-Link, the following solder bridges needs to be removed (see table / board image): |
The ST SPC560D-Discovery evaluation board needs to be setup manually before it can be debugged using an external J-link because by default, the on board debugger drives the debug pins. To isolate the on board debugger from the MCU, in order to make sure that it does not interact with the J-Link, the following solder bridges needs to be removed (see table / board image): |
||
<table> |
<table> |
||
Line 21: | Line 22: | ||
| J111 |
| J111 |
||
|- |
|- |
||
− | | |
+ | | J114 |
|} |
|} |
||
</td> |
</td> |
Latest revision as of 11:29, 15 May 2024
The ST SPC560D-Discovery evaluation board needs to be setup manually before it can be debugged using an external J-link because by default, the on board debugger drives the debug pins. To isolate the on board debugger from the MCU, in order to make sure that it does not interact with the J-Link, the following solder bridges needs to be removed (see table / board image):
|