Difference between revisions of "SPC560D-Discovery Evalboard"
(Created page with "The ST SPC560D-Discovery evaluation board needs to be setup to allow to connect an external J-Link to the MCU as by default, the on board debugger drives the debug pins. To is...") |
(No difference)
|
Revision as of 11:29, 7 June 2016
The ST SPC560D-Discovery evaluation board needs to be setup to allow to connect an external J-Link to the MCU as by default, the on board debugger drives the debug pins. To isolate the on board debugger, in order to make sure that it does not interact with the J-Link, the following solder bridges needs to be removed:
- J101
- J103
- J105
- J109
- J111
- J110
- J114
