STM32H7B3I-EVAL
This article describes specifics for the ST STM32H7B3I-EVAL evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to the 20-pin JTAG debug connector (CN14)
- Power the board via the 5V DC power jack (CN17)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H7B3I-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86d
- Embedded Studio: V7.10
- Hardware: ST STM32H7B3I-EVAL
- Link: File:ST STM32H7B3I-EVAL TestProject ES V710.zip