Difference between revisions of "ST NUCLEO-F031K6"
| Line 7: | Line 7: | ||
*Power the board via CN1 (Micro USB) |
*Power the board via CN1 (Micro USB) |
||
| + | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:F031K6_con.PNG|400px]] |
[[File:F031K6_con.PNG|400px]] |
||
Revision as of 15:13, 1 September 2023
This article describes specifics for the ST NUCLEO-F031K6 evaluation board.
Preparing for J-Link
- Power the board via CN1 (Micro USB)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F031K6.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F031K6
- Link: File:ST NUCLEO-F031K6 TestProject ES V720.zip
