ST NUCLEO-U575ZI-Q

From SEGGER Wiki
Revision as of 13:41, 28 June 2023 by Torben.scharping (talk | contribs) (Torben.scharping moved page NUCLEO-U575ZI-Q to ST NUCLEO-U575ZI-Q)
Jump to: navigation, search

This article describes specifics for the ST NUCLEO-U575ZI-Q evaluation board.
NUCLEO-U575ZI-Q.jpg

Preparing for J-Link

  • Connect the J-Link to CN5.
  • Power the board via CN1.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

VENDOR DEVICE CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-U575ZI-Q.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=ST_NUCLEO-U575ZI-Q&oldid=15367"