Difference between revisions of "ST STM32U5A9NJ"
(Created page with " __TOC__ This article describes specifics for the ST STM32U5A9NJ evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-Link to ........") |
(→SETUP) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 6: | Line 6: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to CN11. |
− | *Power the board via |
+ | *Power the board via CN5. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:STM32U5A9NJ_CONNECT.PNG|400px]] |
[[File:STM32U5A9NJ_CONNECT.PNG|400px]] |
||
Line 14: | Line 14: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U5A9NJ.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U5A9NJ.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: |
+ | *J-Link software: V7.88j |
− | *Embedded Studio: |
+ | *Embedded Studio: V6.34 |
*Hardware: ST STM32U5A9NJ |
*Hardware: ST STM32U5A9NJ |
||
− | *Link: [[File: |
+ | *Link: [[File:ST_STM32U5A9NJ_TestProject_ES_V634.zip]] |
Revision as of 13:20, 28 June 2023
This article describes specifics for the ST STM32U5A9NJ evaluation board.
Preparing for J-Link
- Connect the J-Link to CN11.
- Power the board via CN5.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U5A9NJ.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88j
- Embedded Studio: V6.34
- Hardware: ST STM32U5A9NJ
- Link: File:ST STM32U5A9NJ TestProject ES V634.zip