Difference between revisions of "SemiDrive SD126 E3205 LQFP144 DEV KIT"
Arne.kulinna (talk | contribs) (Created page with "__TOC__ This article describes specifics for the SemiDrive SD126_E3205_LQFP144_DEV_KIT. It can be used to test & verify E32xx device support. File:SemiDrive_SD126_E3205_LQ...") |
Arne.kulinna (talk | contribs) |
||
| Line 9: | Line 9: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link to the JTAG header ( |
+ | *Connect the J-Link to the JTAG header (J301) |
| − | *Power the board via external power supply with 5V |
+ | *Power the board via external power supply with 5V (J801) |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Revision as of 13:48, 24 May 2023
This article describes specifics for the SemiDrive SD126_E3205_LQFP144_DEV_KIT. It can be used to test & verify E32xx device support.
Minimum requirements
- J-Link software V7.88d or later
Preparing for J-Link
- Connect the J-Link to the JTAG header (J301)
- Power the board via external power supply with 5V (J801)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
