Difference between revisions of "Silicon Labs BRD4271A"
(Created page with "__TOC__ This article describes specifics for the Silicon Labs BRD4271A evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for J-...") |
|||
| Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
| − | This article describes specifics for the Silicon Labs BRD4271A evaluation board.<br> |
+ | This article describes specifics for the Silicon Labs BRD4271A (EFR32xG25) extension board installed on the PCB4001 carrier board evaluation board.<br> |
'''[PICTURE OF BOARD]''' |
'''[PICTURE OF BOARD]''' |
||
[[File:VENDOR_BOARDNAME.jpg|450px]] |
[[File:VENDOR_BOARDNAME.jpg|450px]] |
||
Revision as of 11:07, 14 June 2023
This article describes specifics for the Silicon Labs BRD4271A (EFR32xG25) extension board installed on the PCB4001 carrier board evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
