Silicon Labs BRD4271A

This article describes specifics for the Silicon Labs BRD4271A evaluation board.
[PICTURE OF BOARD] 450px

Preparing for J-Link

• Connect the J-Link to ......
• Power the board via........
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT]

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V6.74
• Embedded Studio: V4.52b
• Hardware: [SiliconVendor] [EvalBoardName]
• Link: File:VENDOR DEVICENAME TestProject ES V452b.zip