Silicon Labs BRD4271A

From SEGGER Wiki
Revision as of 11:08, 14 June 2023 by Torben.scharping (talk | contribs) (→‎Preparing for J-Link)
Jump to: navigation, search

This article describes specifics for the Silicon Labs BRD4271A (EFR32xG25) extension board installed on the PCB4001 carrier board evaluation board.
[PICTURE OF BOARD] 450px

Preparing for J-Link

  • Connect the J-Link to the 20-pin debug connector.
  • Power the board using the mini USB connector.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT] VENDOR DEVICE CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Silicon_Labs_BRD4271A&oldid=15199"