Difference between revisions of "Silicon Labs RS9116X-SB-EVK1"
(→Example Project) |
|||
| Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
| − | This article describes specifics for the Silicon Labs RS9116X-SB-EVK1 evaluation board. It can be used to test & verify RS9116 support. |
+ | This article describes specifics for the Silicon Labs RS9116X-SB-EVK1 evaluation board. It can be used to test & verify [[Silicon_Labs_RS9116 | Silicon Labs RS9116]] support. |
[[File:SiLabs_RS9116X_SB_EVK1.jpg|450px]] |
[[File:SiLabs_RS9116X_SB_EVK1.jpg|450px]] |
||
| Line 14: | Line 14: | ||
[[File:JLink_Con_RS9116X_SB_EVK1.JPG|400px]] |
[[File:JLink_Con_RS9116X_SB_EVK1.JPG|400px]] |
||
| − | |||
| − | == Example Project== |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Silicon Labs RS9116X-SB-EVK1. It is a simple Hello World sample linked into the internal flash. |
||
| − | |||
| − | '''SETUP''' |
||
| − | *J-Link software: V6.95b |
||
| − | *Embedded Studio: V5.34 |
||
| − | *Hardware: Silicon Labs RS9116X-SB-EVK1 |
||
| − | *Link: [[File:]] |
||
Latest revision as of 12:39, 19 January 2021
This article describes specifics for the Silicon Labs RS9116X-SB-EVK1 evaluation board. It can be used to test & verify Silicon Labs RS9116 support.
Minimum requirements
- J-Link software V6.95b or later
Preparing for J-Link
- Connect the J-Link to the JTAG/TRACE header (J7)
- Power the board via external USB power supply (J23)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
