Difference between revisions of "Silicon Labs RS9116X-SB-EVK1"
(Created page with "__TOC__ This article describes specifics for the Silicon Labs RS9116X-SB-EVK1 evaluation board. It can be used to test & verify RS9116 support. File:SiLabs_RS9116X_SB_EVK1...") |
(→Preparing for J-Link) |
||
| Line 13: | Line 13: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File:|400px]] |
+ | [[File:JLink_Con_RS9116X_SB_EVK1.JPG|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 12:16, 19 January 2021
This article describes specifics for the Silicon Labs RS9116X-SB-EVK1 evaluation board. It can be used to test & verify RS9116 support.
Minimum requirements
- J-Link software V6.95b or later
Preparing for J-Link
- Connect the J-Link to the JTAG/TRACE header (J7)
- Power the board via external USB power supply (J23)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Silicon Labs RS9116X-SB-EVK1. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: V6.95b
- Embedded Studio: V5.34
- Hardware: Silicon Labs RS9116X-SB-EVK1
- Link: [[File:]]
