Silicon Labs RS9116X-SB-EVK1
This article describes specifics for the Silicon Labs RS9116X-SB-EVK1 evaluation board. It can be used to test & verify RS9116 support.
Minimum requirements
- J-Link software V6.95b or later
Preparing for J-Link
- Connect the J-Link to the JTAG/TRACE header (J7)
- Power the board via external USB power supply (J23)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Silicon Labs RS9116X-SB-EVK1. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: V6.95b
- Embedded Studio: V5.34
- Hardware: Silicon Labs RS9116X-SB-EVK1
- Link: [[File:]]