Syntacore SCR1 SDK Arty
This article describes specifics for the Syntacore Arty SCR1 SDK.
Minimum J-Link hardware requirements
Please note that RISC-V is not supported by older J-Link hardware models / revisions. Overview about which models / revisions support RISC-V
Preparing for J-Link
The Syntacore Arty SCR1 SDK does not come with a standard debug connector but populates the debug JTAG signals on a custom connector. Therefore, it needs to be manually wired in case J-Link shall be connected to it.
In the following, it is described how the pins of connector JD on the ARTY board needs to be wired to J-Link. All pins of the J-Link side refer to the standard 0.1" 20-pin connector of J-Link.
Pin JD (ARTY) | Pin J-Link | Description |
---|---|---|
3 | 3 | nTRST |
4 | 9 | TCK |
7 | 13 | TDO |
8 | 5 | TDI |
9 | 15 | nRESET |
10 | 7 | TMS |
11 | 4 | GND |
12 | 1 | VCC/VTref |
Note: The pins on the JD connector are numbered as follows:
6 | 5 | 4 | 3 | 2 | 1 |
12 | 11 | 10 | 9 | 8 | 7 |