Difference between revisions of "TI CC2340"
(→Device Specific Handling) |
(→Attach) |
||
| Line 33: | Line 33: | ||
===Attach=== |
===Attach=== |
||
Attach is not supported because a device specific initialization sequence is required. |
Attach is not supported because a device specific initialization sequence is required. |
||
| + | ===Security=== |
||
| + | Connecting to a protected device is not supported yet. |
||
==Evaluation Boards== |
==Evaluation Boards== |
||
Revision as of 09:41, 17 May 2023
The TI CC2340 devices are Cortex-M0 based wireless MCUs.
Contents
Flash Banks
Internal Flash
| Flash Bank | Base address | Size | J-Link Support |
|---|---|---|---|
| Program Flash | 0x00000000 | 512 KB | 
|
| CCFG Flash | 0x4E020000 | 2 KB |
|
CCFG Flash
- Describe CCFG Flash restriction here.
!!!TBD!!!
Device Specific Handling
Connect
A device specific connect sequence is executed which supports:
- Connecting to a device with invalid CCFG block. In this case, a default CCFG will be programmed as part of the connect.
- Connecting to a device with valid CCFG block
Reset
The device uses custom reset which performs a reset via the SACI interface:
- In case of a valid application is programmed, the MCU will be halted on the reset vector (application entry point).
- In case of no valid application is programmed, the MCU will be halted in a so called debug loop
Limitations
Flasher Stand-Alone Mode
Not supported yet. Support will be implemented soon.
Attach
Attach is not supported because a device specific initialization sequence is required.
Security
Connecting to a protected device is not supported yet.
Evaluation Boards
- TI LP-EM-CC2340R5 evaluation board: http://wiki.segger.com/TI_LP-EM-CC2340R5
Example Application
- TI LP-EM-CC2340R5 evaluation board: http://wiki.segger.com/TI_LP-EM-CC2340R5#Example_Project
