Difference between revisions of "TI LP-CC1311P3"
| Line 12: | Line 12: | ||
== Example Project== |
== Example Project== |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI Launchpad CC1311P3.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.88g |
*J-Link software: V7.88g |
||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
| − | *Hardware: |
+ | *Hardware: TI Launchpad CC1311P3 |
*Link: [[File:TI_LP-C1311P3_CC1311P3_TestProject_ES_V634.zip]] |
*Link: [[File:TI_LP-C1311P3_CC1311P3_TestProject_ES_V634.zip]] |
||
Revision as of 11:35, 13 June 2023
This article describes specifics for the TI Launchpad CC1311P3 evaluation board.
Preparing for J-Link
- Connect the J-Link to Target In
- Power the board via USB
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI Launchpad CC1311P3.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88g
- Embedded Studio: V6.34
- Hardware: TI Launchpad CC1311P3
- Link: File:TI LP-C1311P3 CC1311P3 TestProject ES V634.zip
