TI LP-MSPM0L2228

TI LP-MSPM0L2228 evaluation board

This article describes specifics for the TI LP-MSPM0L2228 evaluation board. It can be used to test & verify MSPM0Lx228 device support.

Minimum requirements

• J-Link software V7.96d or later

Preparing for J-Link

• Remove SWDIO and SWCLK jumpers of J14.
• Connect the J-Link to the SWD header (XDS110).
• Power the board via the USB jack of the break out board.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:
  

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LP-MSPM0L2228. It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.96d
• Embedded Studio: V8.10
• Hardware: TI LP-MSPM0L2228
• Link: File:TI MSPM0L2228 TestProject ES 8V10.zip