TMPM46BF10FG Evaluation Board

From SEGGER Wiki
Revision as of 11:56, 21 January 2016 by Erik (talk | contribs) (Created page with "The Toshiba TMPM46BF10FG Evaluation Board (TMPM46BF10FG MCU on it) can not be used out-of-the-box with J-Link for two reasons: * The 19-pin cortex-m connector is not populated...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

The Toshiba TMPM46BF10FG Evaluation Board (TMPM46BF10FG MCU on it) can not be used out-of-the-box with J-Link for two reasons:

  • The 19-pin cortex-m connector is not populated
  • The on-board debugger drives the debug interface signals

However, below is a small instruction of which steps needs to be done, to be able to use the board with J-Link.

  • Populate the 19-pin Cortex-M connector (CN2)
  • Close jumper bridge DAPBOOT (CN14) to make sure that the on-board debugger is halted in reset

Flash programming support including the Unlimited Breakpoints in flash feature has been added in V5.11b of the J-Link software and documentation package. So any version >= V5.11b comes with full debug / flash programming support.

Retrieved from "https://wiki.segger.com/index.php?title=TMPM46BF10FG_Evaluation_Board&oldid=280"