Difference between revisions of "Tracing on ST STM32F303"
(→Streaming trace) |
(Redirected page to STM32F3#Tracing) |
||
| Line 1: | Line 1: | ||
| + | #REDIRECT [[STM32F3#Tracing]] |
||
| − | __TOC__ |
||
| − | |||
| − | This article describes how to get started with trace on the ST STM32F303 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read '''Trace''' chapter in the J-Link User Manual (UM08001). |
||
| − | The ST STM32F303 MCU implements tracing via pins, so a J-Trace can be used for tracing. |
||
| − | |||
| − | = Minimum requirements = |
||
| − | In order to use trace on the ST STM32F303 devices, the following minimum requirements have to be met: |
||
| − | * J-Link software version V6.30h or later |
||
| − | * Ozone V2.56e or later (if streaming trace and / or the sample project from below shall be used) |
||
| − | * J-Trace PRO for Cortex-M HW version V1.0 or later |
||
| − | |||
| − | = Sample project = |
||
| − | == Streaming trace == |
||
| − | The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a STM3303C-EVAL Rev.C Evalboard. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
||
| − | |||
| − | [[Media:ST_STM32F303_EVAL_Trace_Example.zip | ST_STM32F303_EVAL_Trace_Example.zip ]] |
||
| − | |||
| − | '''Note:''' The example is shipped with a compiled .JLinkScriptfile, should you need the original source it can be requested at [mailto:support@segger.com support@segger.com] |
||
| − | |||
| − | To create your own .JLinkScriptfile you can use the following project as reference: [https://wiki.segger.com/Tracing_on_ST_STM32F407_(SEGGER_Cortex-M_Trace_Reference_Board) Tracing on SEGGER_Cortex-M_Trace_Reference_Board] |
||
| − | |||
| − | = Tested Hardware = |
||
| − | [[File:STM32F303_EVAL.jpg|left|thumb|STM3303F-EVAL Rev.C]] |
||
Revision as of 10:43, 25 September 2019
Redirect to:
