Tracing on ST STM32F417
This article describes how to get started with trace on the ST STM32F417 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The ST STM32F417 MCU implements tracing via pins, so a J-Trace can be used for tracing.
Sample project
The STM32F417 MCU is comparable To the STM32F407 so the following example project can be used as reference: https://wiki.segger.com/Tracing_on_ST_STM32F407_(SEGGER_Cortex-M_Trace_Reference_Board)
Device specifics
STM3241G-EVAL
Should you be using the STM3241G-EVAL board make sure you apply the following settings before tracing: https://wiki.segger.com/STM3241G-EVAL