Using RTT on RZ A1H
This page explains how to use SEGGER Real-Time-Terminal (RTT) on the Renesas RZ/A1H family devices. As the setup on the target project side is slightly different from IDE to IDE, in the following some sample setups for different IDEs are explained.
SEGGER Embedded Studio
There is a sample project for Embedded Studio available that demonstrates how to configure the project + target application for using RTT with Renesas RZ/A1H. The sample project can be downloaded here: xxxxxxxxxxxxxxxxxxxxxxx
Required components
The following are the minimum requirements to use RTT on the Renesas RZ:
- Embedded Studio V2.14 or later
- A current J-Link model (2015-2016)
- J-Link software V5.11d (beta), V5.20 (release) or later