i.MXRT1020
QSPI support
The RT1020 does not come with internal flash but with external flash connected to the FlexSPI bus, only. The external FlexSPI controller allows to connect several different flash types like QSPI and HyperFlash. Furthermore, the external flash can be connected to different pin / ports of the FlexSPI controller which makes a auto-detection very difficult thus a out-of-the-box solution which works for all setups is kind of impossible. For that reason, the J-Link software supports the evaluation board setup, only. Other setups may work but without any warranty or guarantee from SEGGER. If you are working with a different setup and looking for support for this setup, please get in touch with SEGGER.
Supported QSPI setup
- J-Link Software: >= V6.64
- Hardware: NXP MIMXRT1020-EVK
- Flash: IS25LP064A (QSPI) connected to FlexSPI port A
| Signal Name | GPIO name |
|---|---|
| FlexSPI_SS0 | GPIO_SD_B1_11 |
| FlexSPI_CLK | GPIO_SD_B1_07 |
| FlexSPI_D0_A | GPIO_SD_B1_08 |
| FlexSPI_D1_A | GPIO_SD_B1_10 |
| FlexSPI_D2_A | GPIO_SD_B1_09 |
| FlexSPI_D3_A | GPIO_SD_B1_06 |
Example Application
The application toggles the green USER_LED (D5) on the MIMXRT1020-EVK evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone.
SETUP
- J-Link software: V6.64
- Embedded Studio: V4.50
- Hardware: NXP MIMXRT1020-EVK
- Link: File:NXP MIMXRT1020-EVK QSPI ES.zip
