nRF9131-EK
This article describes specifics for the Nordic Semiconductor nRF9131-EK evaluation board.
Minimum requirements
- J-Link software V7.92m or later
Preparing for J-Link
- Power the board USB Type-C Connector
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nordic Semiconductor nRF9131-EK. It is a simple Hello World sample linked into the internal flash. The project contains a valid boot header so it also run stand-alone (without a debugger attached).
SETUP
- J-Link software: V7.92m
- Embedded Studio: V7.32
- Hardware: nRF9131-EK
- Link: File:NordicSemi nRF9131-EK TestProject ES V732.zip