Raspberry Pi RP2040
This article covers the Raspberry Pi RP2040 device, an arm Cortex-M0+ dualcore MCU with up to 133 MHz Clock. It is the first MCU designed and published by Raspberry Pi. The RP2040 is present on the Raspberry Pi Pico evaluation board.
|Internal flash||No internal flash (ext. QSPI supported)|
|Pins (multifunc)||30 GPIOs|
|Pins (dedicated)||6 SPI IOs|
For further information please refer to the Raspberry Pi Pico web page
The Raspberry Pi RP2040 is fully supported by J-Link.
- Support was implemented with J-Link Software Pack V6.96.
- Only 1st debug session after power-cycle or reset pin toggle successfully connected.
- Since J-Link software V7.50: Power-cycle of MCU after 1st debug session is no longer required.
There are multiple RP2040 evaluation boards. For all of the ones listed below, sample applications are available.
SEGGER Embedded Studio provides a RP2040 board support package for the RP2040 Pico. It is easily adjusted to all other available RP2040 boards, especially, as the QSPI pin-out is not modifiable. Additionally, the articles listed under Evaluation boards all provide sample applications.