Difference between revisions of "i.MX6SoloX"
Line 1: | Line 1: | ||
+ | [[Category:Device families]] |
||
The '''NXP iMX6SoloX''' are multi-core MCUs composed of a Cortex-M4 and Cortex-A9 core. |
The '''NXP iMX6SoloX''' are multi-core MCUs composed of a Cortex-M4 and Cortex-A9 core. |
||
__TOC__ |
__TOC__ |
Latest revision as of 13:06, 15 May 2024
The NXP iMX6SoloX are multi-core MCUs composed of a Cortex-M4 and Cortex-A9 core.
Contents
Flash Banks
QSPI Flash
QSPI flash programming requires special handling compared to internal flash. For more information about this, please see the QSPI Flash Programming Support article.
J-Link supports the following pin configurations for iMX6SoloX:
Alternate function | Port / Pin |
---|---|
QSPI2A_SS0_B | IOMUXC_SW_MUX_CTL_PAD_NAND_ALE |
QSPI2A_DATA2 | IOMUXC_SW_MUX_CTL_PAD_NAND_CE0_B |
QSPI2A_DATA3 | IOMUXC_SW_MUX_CTL_PAD_NAND_CE1_B |
QSPI2A_SCLK | IOMUXC_SW_MUX_CTL_PAD_NAND_CLE |
QSPI2A_DATA1 | IOMUXC_SW_MUX_CTL_PAD_NAND_READY_B |
QSPI2A_DATA0 | IOMUXC_SW_MUX_CTL_PAD_NAND_WP_B |
Multi-Core Support
Before proceeding with this article, please check out the generic article regarding Multi-Core debugging here.
The iMX6SoloX family feature a Cortex-A9 and Cortex-M4 core.
In below, the debug related multi-core behavior of the J-Link is described for each core:
Cortex-A9
Init/Setup
- Enables debugging
Reset
- No Reset is performed.
Secondary core(s)
Init/Setup
- Enables debugging
Reset
- No reset is performed.