Difference between revisions of "ArteryTek AT32F40x"
(→Internal Flash) |
|||
Line 36: | Line 36: | ||
==Evaluation Boards== |
==Evaluation Boards== |
||
− | *[[ |
+ | *[[ArteryTek_AT-START-F402|ArteryTek AT-START-F402]] |
− | *[[ |
+ | *[[ArteryTek_AT-START-F403A|ArteryTek AT-START-F403A]] |
− | *[[ |
+ | *[[ArteryTek_AT-START-F405|ArteryTek AT-START-F405]] |
− | *[[ |
+ | *[[ArteryTek_AT-START-F407|ArteryTek AT-START-F407]] |
==Example Application== |
==Example Application== |
||
− | *[[ |
+ | *[[ArteryTek_AT-START-F402#Example_Project | ArteryTek AT-START-F402]] |
− | *[[ |
+ | *[[ArteryTek_AT-START-F403A#Example_Project | ArteryTek AT-START-F403A]] |
− | *[[ |
+ | *[[ArteryTek_AT-START-F405#Example_Project | ArteryTek AT-START-F405]] |
− | *[[ |
+ | *[[ArteryTek_AT-START-F407#Example_Project | ArteryTek AT-START-F407]] |
Revision as of 16:34, 8 February 2024
Artery AT32F40x are Cortex-M4 based MCUs
Contents
Flash Banks
Internal Flash
Flash Bank | Base address | Size | J-Link Support |
---|---|---|---|
Internal flash | 0x08000000 | Up to 1024KB | |
SPIM external flash | 0x08400000 | Up to 16 MB |
The SPIM support is currently under development.
QSPI Flash
QSPI flash programming requires special handling compared to internal flash. For more information about this, please see the QSPI Flash Programming Support article.
J-Link supports multiple pin configurations for AT32F40x. The default loader is marked in bold.
Device | Base address | Maximum size | Supported pin configuration |
---|---|---|---|
AT32F402 AT32F405 |
0x90000000 | Up to 64 MB |
|
Watchdog Handling
- The watchdog is fed during flash programming.
Device Specific Handling
Reset
- The device uses normal Cortex-M reset, no special handling necessary, like described here.